ALBUTEROL SULFATE solution

Albuterol Sulfate by

Drug Labeling and Warnings

Albuterol Sulfate by is a Prescription medication manufactured, distributed, or labeled by American Health Packaging. Drug facts, warnings, and ingredients follow.

Drug Details [pdf]

Storage

PROTECT FROM LIGHT. Store in pouch until time of use. Store between 2° and 25° C (36° and 77° F).

Rx only.

To report SUSPECTED ADVERSE REACTIONS, contact American Health Packaging at 1-800-707-4621 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch

  • SPL UNCLASSIFIED SECTION

    Manufactured by: The Ritedose Corporation, Columbia, SC 29203
    Distributed by: American Health Packaging, Columbus, OH 43217

    RPIN0101
    September 2018

  • Patient's Instructions for Use

    Albuterol Sulfate Inhalation Solution 0.083%2
    Note: This is a unit-dose vial. No dilution is required.

    Read complete instructions carefully before using.

    1. Remove the vial from the foil pouch.
    2. Twist the cap completely off the vial and squeeze the contents into the nebulizer reservoir (Figure 1).
    3. Connect the nebulizer reservoir to the mouthpiece or face mask (Figure 2).
    4. Connect the nebulizer to the compressor.
    5. Sit in a comfortable, upright position; place the mouthpiece in your mouth (Figure 3) (or put on the face mask); and turn on the compressor.
    6. Breathe as calmly, deeply and evenly as possible until no more mist is formed in the nebulizer chamber (about 5 to 15 minutes). At this point, the treatment is finished.
    7. Clean the nebulizer (see manufacturer's instructions).

    Figures

    Note: Use only as directed by your physician. More frequent administration or higher doses are not recommended.

    Store Albuterol Sulfate Inhalation Solution 0.083%2 between 2° and 25° C (36° and 77° F). Store in pouch until time of use.

    ADDITIONAL INSTRUCTIONS: ______________________________________________________________________________________

    To report SUSPECTED ADVERSE REACTIONS, contact American Health Packaging at 1-800-707-4621 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch

    Manufactured by:
    The Ritedose Corporation
    Columbia, SC 29203

    Distributed by:
    American Health Packaging
    Columbus, OH 43217

    RPIN0101
    September 2018


  • 2 (Potency expressed as albuterol, equivalent to 3 mg albuterol sulfate).
  • Package/Label Display Panel – Carton – 2.5 mg per 3 mL

    2.5 mg per 3 mL Albuterol Inhalation Solution Carton

    NDC 60687- 395-83

    Albuterol Sulfate
    Inhalation Solution, 0.083%*

    2.5 mg/3 mL*
    *Potency expressed as albuterol, equivalent to 3 mg albuterol sulfate.

    30 x 3 mL Sterile Unit-Dose Vials,
    each in a foil pouch.

    Rx Only
    FOR ORAL INHALATION ONLY

    Each mL contains 1 mg albuterol sulfate, equivalent to 0.83 mg albuterol in an aqueous solution containing
    sodium chloride and sulfuric acid to adjust pH between 3 and 5. Contains no preservatives.

    Equivalent to 0.5 mL Albuterol Sulfate 0.5%* diluted to 3 mL with normal saline.

    Usual Dosage: See package insert.
    Please consult your physician before use. Do not exceed recommended dosage.

    Protect from light. Store between 2º and 25ºC (36º and 77ºF). Discard if solution becomes discolored.
    (Note: Albuterol Sulfate Inhalation Solution is a clear, colorless to light yellow solution.)

    Rx Only

    Attention Pharmacist: Detach "Patient's Instructions For Use"
    from package insert and dispense with solution.

    Manufactured by: The Ritedose Corporation, Columbia, SC 29203
    Distributed by: American Health Packaging, Columbus, OH 43217

  • Package/Label Display Panel – Pouch – 2.5 mg per 3 mL

    Albuterol Sulfate Inhalation Solution Foil Label

    NDC: 60687-395-79

    Albuterol Sulfate
    Inhalation Solution,
    0.083%*

    2.5 mg/3 mL*

    * Potency expressed as albuterol,
    equivalent to 3 mg albuterol sulfate.

    FOR ORAL INHALATION ONLY

    Equivalent to 0.5 mL albuterol
    sulfate 0.5%* diluted to 3 mL with
    normal saline.

    Each mL contains 1 mg albuterol
    sulfate, equivalent to 0.83 mg
    albuterol, in an aqueous solution
    containing sodium chloride and
    sulfuric acid to adjust pH between 3
    and 5. Contains no preservatives.

    Please consult your physician before
    use. Do not exceed recommended
    dosage.

    Usual Dosage: See package insert.

    Store between 2º and 25ºC (36º and
    77ºF). Protect from light.

    Discard if solution becomes
    discolored. (Note: Albuterol Sulfate
    Inhalation Solution is a clear, colorless
    to light yellow solution.)

    Attention Pharmacist: Detach
    "Patient's Instructions For Use"
    from package insert and dispense with
    solution.

    Rx Only

    STERILE

    One 3 mL Unit-Dose Vial

    Manufactured by:
    The Ritedose
    Corporation
    Columbia, SC 29203

    Distributed by:
    American Health
    Packaging
    Columbus, OH 43217

    RPFP0222

  • INGREDIENTS AND APPEARANCE
    ALBUTEROL SULFATE 
    albuterol sulfate solution
    Product Information
    Product TypeHUMAN PRESCRIPTION DRUGItem Code (Source)NDC: 60687-395
    Route of AdministrationRESPIRATORY (INHALATION)
    Active Ingredient/Active Moiety
    Ingredient NameBasis of StrengthStrength
    ALBUTEROL SULFATE (UNII: 021SEF3731) (ALBUTEROL - UNII:QF8SVZ843E) ALBUTEROL2.5 mg  in 3 mL
    Inactive Ingredients
    Ingredient NameStrength
    WATER (UNII: 059QF0KO0R)  
    SODIUM CHLORIDE (UNII: 451W47IQ8X)  
    SULFURIC ACID (UNII: O40UQP6WCF)  
    Packaging
    #Item CodePackage DescriptionMarketing Start DateMarketing End Date
    1NDC: 60687-395-8330 in 1 CARTON12/26/2018
    1NDC: 60687-395-791 in 1 POUCH
    13 mL in 1 AMPULE; Type 0: Not a Combination Product
    Marketing Information
    Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
    ANDAANDA07783912/26/2018
    Labeler - American Health Packaging (929561009)

  • © 2024 FDA.report
    This site is not affiliated with or endorsed by the FDA.