{"active_ingredient":["ACTIVE INGREDIENT Active Ingredient: Glycerin 7.0%"],"dosage_and_administration":["DOSAGE & ADMINISTRATION Dosage & Administration: Take an adequate amount of this product."],"effective_time":"20170727","id":"55552c93-c6fb-5d5d-e054-00144ff8d46c","inactive_ingredient":["INACTIVE INGREDIENT Inactive Ingredients: Water, Sodium Bicarbonate, Triethanolamine, Algin, Butylene Glycol, Anthemis Nobilis Flower Extract, Carbomer, Phenoxyethanol, Methylparaben, Phellinus Linteus Extract, Butyl Avocadate, Lilium Candidum Bulb Extract, Iris Versicolor Extract, Freesia Alba Flower Extract, Narcissus Pseudo-Narcissus (Daffodil) Flower Extract, Rosa Damascena Flower Water, Leontopodium Alpinum Extract, Nelumbo Nucifera Flower Extract, Jasminum Officinale (Jasmine) Flower/Leaf Extract, Ascorbic Acid, Propyl Gallate"],"indications_and_usage":["Directions & Usage Directions & Usage: 1. Dispense No.1 agent gel 20ml on the sheet 2. Attach the sheet to the face 3. After 20~30 minutes, remove the sheet and rinse the face with warm water"],"keep_out_of_reach_of_children":["KEEP OUT OF REACH OF CHILDREN Keep out of reach of children"],"openfda":{},"package_label_principal_display_panel":["PACKAGE LABEL.PRINCIPAL DISPLAY PANEL Image of carton"],"purpose":["PURPOSE Purpose: Skin Protectant"],"set_id":"ebaec2e9-f939-45ef-8507-c1042c9efb8f","spl_product_data_elements":["CO2 CARBONIC PACK Glycerin WATER SODIUM BICARBONATE GLYCERIN GLYCERIN"],"version":"2","warnings":["WARNINGS Warnings: 1. If any of the following symptoms appear on the area where the product was applied, stop using the product immediately and consult a specialist. A. Redness, swelling, itchiness, irritation or other abnormal symptoms B. Symptoms above appear after exposure to direct sunlight 2. DO NOT use the product on an area with wound, eczema, or dermatitis 3. Storage and dealings warnings. A. Close tight after use B. Keep out of reach of children C. Do not keep the product in high or low temperature and keep out of sun 4. Avoid delicate eye area 5. The applied area can turn red or be felt hot, but such symptoms can occur from temperature rise from CO2 generation and will be normalized after a while. 6. Use after you read usage and caution thoroughly"]}