GEA BI-SEPT BASE PRE-POST MILKING NON-IODINE TEAT DIP- non-iodine teat dip liquid
GEA Bi-Sept Base Pre-Post Milking Non-Iodine Teat Dip by
Drug Labeling and Warnings
GEA Bi-Sept Base Pre-Post Milking Non-Iodine Teat Dip by is a Animal medication manufactured, distributed, or labeled by GEA Farm Technologies, Inc.. Drug facts, warnings, and ingredients follow.
Drug Details [pdf]
- ACTIVE INGREDIENT
- SPL UNCLASSIFIED SECTION
- KEEP OUT OF REACH OF CHILDREN
- PRECAUTIONS
-
USER SAFETY WARNINGS
FIRST AID
If in Eyes: Flush with large volumes of water for at least 15 minutes. Call a physician immediately.
If Swallowed: DO NOT induce vomiting. Rinse mouth promptly, then give small amount/glass of water (4-6 oz. child / 10-12 oz. adult). Avoid alcohol. Call a physician immediately. DO NOT give anything by mouth to an unconscious or convulsing person.
If on Skin: Flush with large volumes of water for at least 15 minutes while removing contaminated clothing and shoes. If irritation develops and persists, get medical attention.
Inhalation of Vapors: If breathing difficulty or irritation occurs, remove to fresh air. If symptoms persist, get medical attention.FOR ASSISTANCE WITH MEDICAL EMERGENCY
CALL 1-877-741-1032.
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- INDICATIONS & USAGE
-
DOSAGE & ADMINISTRATION
DIRECTIONS FOR USE: Use only when properly mixed with Bi-Sept Activator. Do not dilute. Always prepare mixture in a ventilated area: add ONE volume of Bi-Sept Base to ONE volume of Bi-Sept Activator to a clean container. Mix thoroughly. Once mixed, product can remain effective for up to three days. However, for optimum results, it is recommended to use each Bi-Sept Activator / Base mixture no longer tha 24 hours.
PRE DIPPING: Before milking, dip each teat with Bi-Sept. After 15 to 30 seconds, dry each treat thoroughly with a single service towel. If the udder and teats are heavily soiled, wash with a sanitizing solution and dry before application of Bi-Spet teat dip.
POST DIPPING: Immediately after milking, dip each teat with Bi-Sept. Allow teats to air dry. Do not wipe. If outside temperature is below freezing, allow to air dry on the teat before the cow leaves the parlor to prevent freezing. At the end of lactation, apply this product daily for one week after the last milking. In addition, begin application of this product about one week prior to calving. If a common teat dip cup is used for application, a fresh solution should always be used at each milking. The teat dip cup should be emptied, cleaned and rinsed with potable water after each milking session or when cup becomes contaminated during milking. Do not pour remaining solution from dip cup back into original container.
- STORAGE AND HANDLING
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- SPL UNCLASSIFIED SECTION
- PRINCIPAL DISPLAY PANEL
- PRINCIPAL DISPLAY PANEL
-
INGREDIENTS AND APPEARANCE
GEA BI-SEPT BASE PRE-POST MILKING NON-IODINE TEAT DIP
non-iodine teat dip liquidProduct Information Product Type OTC ANIMAL DRUG Item Code (Source) NDC: 51070-7015 Route of Administration TOPICAL Active Ingredient/Active Moiety Ingredient Name Basis of Strength Strength SODIUM CHLORITE (UNII: G538EBV4VF) (CHLORITE ION - UNII:Z63H374SB6) SODIUM CHLORITE 0.7 g in 100 g Packaging # Item Code Package Description Marketing Start Date Marketing End Date 1 NDC: 51070-7015-3 56700 g in 1 DRUM 2 NDC: 51070-7015-2 18900 g in 1 JUG 3 NDC: 51070-7015-5 208000 g in 1 DRUM 4 NDC: 51070-7015-6 945000 g in 1 CONTAINER Marketing Information Marketing Category Application Number or Monograph Citation Marketing Start Date Marketing End Date unapproved drug other 12/01/2010 Labeler - GEA Farm Technologies, Inc. (018037309)
© 2025 FDA.report
This site is not affiliated with or endorsed by the FDA.