Hazard statement(s):
Causes skin irritation, Causes serious eye irritation.
Precautionary statement(s):
Wash hands, forearms and face thoroughly after handling. Do not eat, drink or smoke while
using this product. Wear protective gloves, clothing, and eye and face protection.
Hazards not otherwise classified: None Known
Storage and Disposal: Store in a well-ventilated place. Keep cool. Dispose of contents/container in
accordance with licensed collector’s sorting instructions.
First Aid:
External: Immediately flush skin with plenty of cool, running water for at least 15 minutes
while removing contaminated clothing and shoes. Wash clothing before reuse.
Eyes: Immediately flush with plenty of cool, running water. Remove contact lenses; then
continue flushing for at least 15 minutes, holding eyelids apart.
Internal: Call a physician immediately. If swallowed, do not induce vomiting. Rinse mouth,
then immediately drink one or two large glasses of water or milk. Never give anything by
mouth to an unconscious person.
Inhalation of vapors: Immediately move to fresh air. Get medical attention immediately.
Most important symptoms/effects, acute and delayed: None known
Immediate medical attention and special treatment needed, if any: Emergency treatment
if irritation or redness occurs to the skin.
Cover All™ is a concentrated two part stabilized chlorine dioxide teat dip that will aid in the
prevention of the spread of mastitis causing organisms. Ample amounts of skin conditioners
in Cover All™ keep teats soft and smooth. Cover All™ contains alpha hydroxy acids to aid in
the exfoliation of teat skin and soften the hyperkeratosis at the teat end.
MIXING INSTRUCTIONS:
Cover All™ is a two part concentrate that must be mixed prior to use. The mix ratio is
18:1:1. Mix enough Cover All™ to last for 24 hours. In a clean container add 18 parts water,
1 part of Cover All RF Part A™ or Cover all Part A™, and 1 part Cover All Part B™. Mix gently
and let stand for a minimum of 15 minutes. The mixed solution will reach or exceed 800
ppm chlorine dioxide within 15 minutes. Keep the containers tightly closed and store in a
cool, dry area away from direct sunlight.
USE INSTRUCTIONS:
Pre-Dipping: If teats are dirty, pre-clean with a suitable udder wash and a single service
towel. Dip, spray or foam each teat with Cover All™ chlorine dioxide. Leave on teats a
minimum of 15-30 seconds. Wipe teats dry with a single service towel and apply milker
units.
Post-Dipping: Immediately after milking, dip each teat with Cover All™ chlorine dioxide teat
dip. Allow to air dry.
Always use this mixture full strength. If product in dip cup becomes dirty, discard contents
and fill with a fresh solution.
If teat irritation occurs, discontinue use until irritation subsides. Consult your veterinarian if
irritation persists.
Ingredients:
Sodium Chlorite: 2.69%