DIRECTIONS FOR USE: Use only when properly mixed with Bi-Sept Base. Do not dilute. Always prepare mixture in a ventilated area: add ONE volume of Bi-Sept Activatorto ONE volume of Bi-Sept Base to a clean container. Mix thoroughly. Once mixed, product can remain effective for up to three days. However, for optimum results, it is recommended to use each Bi-Sept Activator / Base mixture no longer tha 24 hours.
PRE DIPPING: Before milking, dip each teat with Bi-Sept. After 15 to 30 seconds, dry each treat thoroughly with a single service towel. If the udder and teats are heavily soiled, wash with a sanitizing solution and dry before application of Bi-Spet teat dip.
POST DIPPING: Immediately after milking, dip each teat with Bi-Sept. Allow teats to air dry. Do not wipe. If outside temperature is below freezing, allow to air dry on the teat before the cow leaves the parlor to prevent freezing. At the end of lactation, apply this product daily for one week after the last milking. In addition, begin application of this product about one week prior to calving. If a common teat dip cup is used for application, a fresh solution should always be used at each milking. The teat dip cup should be emptied, cleaned and rinsed with potable water after each milking session or when cup becomes contaminated during milking. Do not pour remaining solution from dip cup back into original container.