VETERINARY 0.9% SODIUM CHLORIDE- sodium chloride injection, solution

Veterinary 0.9% Sodium Chloride by

Drug Labeling and Warnings

Veterinary 0.9% Sodium Chloride by is a Animal medication manufactured, distributed, or labeled by Assure Infusions, Inc. Drug facts, warnings, and ingredients follow.

Drug Details [pdf]

SPL UNCLASSIFIED SECTION

For Animal Use Only

Description

Description:
Veterinary 0.9% Sodium Chloride Injection, USP is a sterile, nonpyrogenic solution for fluid and electrolyte replenishment in single dose containers for parenteral administration. It contains no antimicrobial agents. Discard unused portion.

Clinical Pharmacology

Veterinary 0.9% Sodium Chloride Injection, USP has value as a source of water and electrolytes. It is capable of inducing diuresis depending on the clinical condition

of the patient.

Indications and Usage

Veterinary 0.9% Sodium Chloride Injection, USP is indicated as a source of water and electrolytes.

Contraindications

None known. 

Warnings

Sodium Chloride Injection, USP should be used with great care, if at all, in patients with congestive heart failure, severe renal insufficiency, and in clinical states in which there exists edema with sodium retention.

The intravenous administration of Sodium Chloride Injection, USP can cause fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, overhydration, congested states, or pulmonary edema. The risk of dilutive states is inversely proportional to the electrolyte concentration of the injections. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentrations of the injections.

In patients with diminished renal function, administration of Sodium Chloride Injection, USP may result in sodium retention.

Adverse Reactions

Reactions which may occur because of the solution or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation, and hypervolemia. If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures, and save the remainder of the fluid for examination if deemed necessary.

Precautions

Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations, and acid base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation.
Caution must be exercised in the administration of Veterinary 0.9% Sodium Chloride Injection, USP to patients receiving corticosteroids or corticotropin. Do not administer unless solution is clear and seal is intact.

Dosage and Administration

As directed by a veterinarian. Dosage is dependent upon the age, weight and clinical condition of the patient, as well as laboratory determinations.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.
All solutions for injection contained in plastic containers are intended for administration using sterile equipment and aseptic technique. Additives may be incompatible. Complete information is not available. Those additives known to be incompatible should not be used. Consult with pharmacist, if available. If, in the informed judgment of the veterinarian, it is deemed advisable to introduce additives, use aseptic technique. Mix thoroughly when additives have been introduced.
Do not store solutions containing additives. Discard unused portion.

Over Dosage

In an event of overhydration or solute overload, re-evaluate the patient and institute appropriate corrective measures.
See Warnings, Adverse Reactions and Precautions.

How Supplied

Veterinary 0.9% Sodium Chloride Injection, USP is supplied in plastic bags as follows:
The plastic container is fabricated from a multi-layer, Polyolefin/Styrene-block copolymer film. The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly.

Storage:

Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended the product be stored in the moisture overwrap at room temperature (25ºC/77ºF); brief exposure up to (40ºC/104ºF) does not adversely affect the product.

Directions for use of plastic container

To Open
Tear overwrap down side at slit and remove solution bag. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed.
This is normal and does not affect the solution quality or safety.The opacity will diminish gradually. Check for minute leaks by squeezing inner bag firmly. If leaks
are found, discard solution as sterility may be impaired. If supplemental medication is desired, follow directions below.
Preparation for Administration
1. Suspend container from eyelet support.
2. Remove protector from outlet port at bottom of container.
3. Attach administration set. Refer to complete directions accompanying set.
To Add Medication
WARNING: Additives may be incompatible.
To add medication before solution administration
1. Prepare medication site.
2. Using syringe with 19 to 22 gauge needle, puncture resealable medication port and inject.
3. Mix solution and medication thoroughly. For high density medication such as potassium chloride, turn bag so ports are upright, and no liquid remains in
ports and mix thoroughly.
To add medication during solution administration
1. Close clamp on the administration set to stop the flow to the patient.
2. Prepare medication port.
3. Using syringe with 19 to 22 gauge needle, puncture resealable medication port and inject.
4. Remove container from IV pole and/or turn to an upright position.
5. Evacuate both ports while container is in the upright position.
6. Mix solution and medication thoroughly.
7. Return container to in-use position and continue administration.

PRINCIPAL DISPLAY PANEL

INGREDIENTS AND APPEARANCE

VETERINARY 0.9% SODIUM CHLORIDE 
sodium chloride injection, solution

Product Information
Product Type	PRESCRIPTION ANIMAL DRUG	Item Code (Source)	NDC: 83155-200
Route of Administration	INTRAVENOUS

Active Ingredient/Active Moiety
Ingredient Name	Basis of Strength	Strength
SODIUM CHLORIDE (UNII: 451W47IQ8X) (SODIUM CATION - UNII:LYR4M0NH37, CHLORIDE ION - UNII:Q32ZN48698)	SODIUM CHLORIDE	900 mg  in 100 mL

Inactive Ingredients
Ingredient Name	Strength
WATER (UNII: 059QF0KO0R)

Packaging
#	Item Code	Package Description	Marketing Start Date	Marketing End Date
1	NDC: 83155-200-50	500 mL in 1 BAG
2	NDC: 83155-200-10	1000 mL in 1 BAG
3	NDC: 83155-200-25	250 mL in 1 BAG

Marketing Information
Marketing Category	Application Number or Monograph Citation	Marketing Start Date	Marketing End Date
UNAPPROVED DRUG OTHER		05/30/2025

Labeler - Assure Infusions, Inc (053016941)

Establishment
Name	Address	ID/FEI	Business Operations
Assure Infusions, Inc		053016941	manufacture, api manufacture