The MOR is a self-tapping, small diameter, screw implant, manufactured from titanium alloy (6% Al, 4% V – ASTM F136). The portion of the implant that is submerged in the bone is grit blasted and acid etched. The implants are manufactured with two body diameters, 2.1 mm and 2.4 mm. They are packaged sterile in a double blister, which contains: the implant in a titanium tube. The MOR implant body is designed with an O-ball denture connection and a separate straight titanium alloy (6% AI, 4% V – ASTM F136) abutment which may be cemented over the O-ball for crown or bridge fixation. The MOR Implant System is not intended for correction of implants placed at an angle. It is only intended for use with straight abutments. The MOR implant body is intended to be placed such that no angle correction is necessary. It is intended for long-term applications in the bone of the patient’s upper or lower arch. The MOR implants may also be used for inter-radicular transitional applications. These devices will permit immediate splinting stability and long-term fixation of new or existing crown and bridge installations, for full or partial edentulous cases, and employing minimally invasive surgical intervention.
A prefabricated device intended to provide a permanent intermediate fixture level between a dental implant and the final prosthesis/restoration (e.g., bridge, single tooth, overdenture). It includes one or more structural component(s) [e.g., abutment, ball, bar, bar overlay, coping, ring], and may be made of various materials [e.g., titanium (Ti), plastic, gold alloy]. It includes devices glued to prostheses and/or devices that can be replaced during cleaning cycles. An abutment screw(s) may be included, however the suprastructure does not represent the screw(s) in isolation. It may also be referred to as an abutment assembly or mesostructure.
sterngold.com