DOSAGE AND ADMINISTRATION
Table 1 (Recommended Dosages) summarizes the
recommended volumes and concentrations of Lidocaine Hydrochloride
Injection, USP for various types of anesthetic procedures. The dosages
suggested in this table are for normal healthy adults and refer to the
use of epinephrine-free solutions. When larger volumes are required only
solutions containing epinephrine should be used, except in those cases
where vasopressor drugs may be contraindicated.
There have been adverse event reports of chondrolysis in patients
receiving intra-articular infusions of local anesthetics following
arthroscopic and other surgical procedures. Lidocaine is not approved
for this use (see WARNINGS and DOSAGE AND ADMINISTRATION).
These recommended doses serve only as a guide to the amount of
anesthetic required for most routine procedures. The actual volumes and
concentrations to be used depend on a number of factors such as type and
extent of surgical procedure, depth of anesthesia and degree of
muscular relaxation required, duration of anesthesia required, and the
physical condition of the patient. In all cases the lowest concentration
and smallest dose that will produce the desired result should be given.
Dosages should be reduced for children and for elderly and debilitated
patients and patients with cardiac and/or liver disease.
The onset of anesthesia, the duration of anesthesia and the degree of
muscular relaxation are proportional to the volume and concentration
(i.e., total dose) of local anesthetic used. Thus, an increase in volume
and concentration of Lidocaine Hydrochloride Injection will decrease
the onset of anesthesia, prolong the duration of anesthesia, provide a
greater degree of muscular relaxation and increase the segmental spread
of anesthesia. However, increasing the volume and concentration of
Lidocaine Hydrochloride Injection may result in a more profound fall in
blood pressure when used in epidural anesthesia. Although the incidence
of side effects with lidocaine is quite low, caution should be exercised
when employing large volumes and concentrations, since the incidence of
side effects is directly proportional to the total dose of local
anesthetic agent injected.
For intravenous regional anesthesia, only the 50 mL single-dose vial
containing 0.5% Lidocaine Hydrochloride Injection, USP should be used.
Epidural Anesthesia
For epidural anesthesia, only the following available specific products of Lidocaine Hydrochloride Injection by Hospira are recommended:
1%. . . . . . . . . . . . . . . . . . . . 30 mL single-dose teartop vials
1.5%. . . . . . . . . . . . . . . . . . . . . . . 20 mL single-dose ampuls
2%. . . . . . . . . . . . . . . . . . . . . . . . . 10 mL single-dose ampuls
Although these solutions are intended specifically for epidural
anesthesia, they may also be used for infiltration and peripheral nerve
block provided they are employed as single dose units. These solutions
contain no bacteriostatic agent. In epidural anesthesia, the dosage
varies with the number of dermatomes to be anesthetized (generally 2−3
mL of the indicated concentration per dermatome).
Caudal and Lumbar Epidural Block:
As a precaution against the adverse experiences sometimes observed
following unintentional penetration of the subarachnoid space, a test
dose such as 2−3 mL of 1.5% lidocaine hydrochloride should be
administered at least 5 minutes prior to injecting the total volume
required for a lumbar or caudal epidural block. The test dose should be
repeated if the patient is moved in a manner that may have displaced the
catheter. Epinephrine, if contained in the test dose (10−15 mcg have
been suggested), may serve as a warning of unintentional intravascular
injection. If injected into a blood vessel, this amount of epinephrine
is likely to produce a transient "epinephrine response" within 45
seconds, consisting of an increase in heart rate and systolic blood
pressure, circumoral pallor, palpitations and nervousness in the
unsedated patient. The sedated patient may exhibit only a pulse rate
increase of 20 or more beats per minute for 15 or more seconds. Patients
on beta-blockers may not manifest changes in heart rate, but blood
pressure monitoring can detect an evanescent rise in systolic blood
pressure. Adequate time should be allowed for onset of anesthesia after
administration of each test dose. The rapid injection of a large volume
of Lidocaine Hydrochloride Injection through the catheter should be
avoided, and, when feasible, fractional doses should be administered.
In the event of the known injection of a large volume of local
anesthetic solutions into the subarachnoid space, after suitable
resuscitation and if the catheter is in place, consider attempting the
recovery of drug by draining a moderate amount of cerebrospinal fluid
(such as 10 mL) through the epidural catheter.
Maximum Recommended Dosages
NOTE: The products accompanying this insert do not contain epinephrine.
Adults: For
normal healthy adults, the individual maximum recommended dose of
lidocaine HCl with epinephrine should not exceed 7 mg/kg (3.5 mg/lb) of
body weight and in general it is recommended that the maximum total dose
not exceed 500 mg. When used without epinephrine, the maximum
individual dose should not exceed 4.5 mg/kg (2 mg/lb) of body weight and
in general it is recommended that the maximum total dose does not
exceed 300 mg. For continuous epidural or caudal anesthesia, the maximum
recommended dosage should not be administered at intervals of less than
90 minutes. When continuous lumbar or caudal epidural anesthesia is
used for non-obstetrical procedures, more drug may be administered if
required to produce adequate anesthesia.
The maximum recommended dose per 90 minute period of lidocaine
hydrochloride for paracervical block in obstetrical patients and
non-obstetrical patients is 200 mg total. One-half of the total dose is
usually administered to each side. Inject slowly five minutes between
sides. (See also discussion of paracervical block in PRECAUTIONS).
For intravenous regional anesthesia, the dose administered should not exceed 4 mg/kg in adults.
Children: It is
difficult to recommend a maximum dose of any drug for children, since
this varies as a function of age and weight. For children over 3 years
of age who have a normal lean body mass and normal body development, the
maximum dose is determined by the child’s age and weight. For example,
in a child of 5 years weighing 50 lbs., the dose of lidocaine HCl should
not exceed 75 — 100 mg (1.5 — 2 mg/lb). The use of even more dilute
solutions (i.e., 0.25 — 0.5%) and total dosages not to exceed 3 mg/kg
(1.4 mg/lb) are recommended for induction of intravenous regional
anesthesia in children.
In order to guard against systemic toxicity, the lowest effective
concentration and lowest effective dose should be used at all times. In
some cases it will be necessary to dilute available concentrations with
0.9% sodium chloride injection in order to obtain the required final
concentration.
Parenteral drug products should be inspected visually for particulate
matter and discoloration prior to administration whenever the solution
and container permit. Solutions that are discolored and/or contain
particulate matter should not be used.
Table 1 |
Recommended Dosages of Lidocaine Hydrochloride Injection, USP for Various Anesthetic |
Procedures in Normal Healthy Adults |
|
|
| Lidocaine Hydrochloride Injection, USP (without Epinephrine) |
|
|
|
|
Procedure | Conc. (%) | Vol. (mL) | Total Dose (mg) |
|
|
|
|
Infiltration |
|
|
|
Percutaneous | 0.5 or 1.0 | 1−60 | 5−300 |
Intravenous Regional | 0.5 | 10−60 | 50−300 |
|
|
|
|
Peripheral Nerve Blocks, e.g. |
|
|
|
Brachial | 1.5 | 15−20 | 225−300 |
Dental | 2.0 | 1−5 | 20−100 |
Intercostal | 1.0 | 3 | 30 |
Paravertebral | 1.0 | 3−5 | 30−50 |
Pudendal (each side) | 1.0 | 10 | 100 |
Paracervical |
|
|
|
Obstetrical Analgesia |
|
|
|
(each side) | 1.0 | 10 | 100 |
|
|
|
|
Sympathetic Nerve Blocks, e.g. |
|
|
|
Cervical (stellate ganglion) | 1.0 | 5 | 50 |
Lumbar | 1.0 | 5−10 | 50−100 |
|
|
|
|
Central Neural Blocks |
|
|
|
Epidural* |
|
|
|
Thoracic | 1.0 | 20−30 | 200−300 |
Lumbar |
|
|
|
Analgesia | 1.0 | 25−30 | 250−300 |
Anesthesia | 1.5 | 15−20 | 225−300 |
| 2.0 | 10−15 | 200−300 |
Caudal |
|
|
|
Obstetrical Analgesia | 1.0 | 20−30 | 200−300 |
Surgical Anesthesia | 1.5 | 15−20 | 225−300 |
|
|
|
|
|
*Dose determined by number of dermatomes to be anesthetized (2 to 3 mL/dermatome). |
THE ABOVE SUGGESTED CONCENTRATIONS AND VOLUMES SERVE ONLY AS A GUIDE.
OTHER VOLUMES AND CONCENTRATIONS MAY BE USED PROVIDED THE TOTAL MAXIMUM
RECOMMENDED DOSE IS NOT EXCEEDED.
Sterilization, Storage and Technical Procedures:
Disinfecting agents containing heavy metals, which cause release of
respective ions (mercury, zinc, copper, etc.) should not be used for
skin or mucous membrane disinfection as they have been related to
incidence of swelling and edema. When chemical disinfection of
multi-dose vials is desired, either isopropyl alcohol (91%) or 70% ethyl
alcohol is recommended. Many commercially available brands of rubbing
alcohol, as well as solutions of ethyl alcohol not of USP grade, contain
denaturants which are injurious to rubber and, therefore, are not to be
used. It is recommended that chemical disinfection be accomplished by
wiping the vial stopper thoroughly with cotton or gauze that has been
moistened with the recommended alcohol just prior to use.