Amoxicillin is a semisynthetic antibiotic with a broad spectrum of bactericidal
activity against many gram-positive and gram-negative microorganisms.
Amoxicillin is, however, susceptible to degradation by β-lactamases and,
therefore, the spectrum of activity does not include organisms which produce
these enzymes. Clavulanic acid is a β-lactam, structurally related to the
penicillins, which possesses the ability to inactivate a wide range of
β-lactamase enzymes commonly found in microorganisms resistant to penicillins
and cephalosporins. In particular, it has good activity against the clinically
important plasmid-mediated β-lactamases frequently responsible for transferred
drug resistance.
The formulation of amoxicillin and clavulanic acid in amoxicillin/clavulanate
potassium protects amoxicillin from degradation by β-lactamase enzymes and
effectively extends the antibiotic spectrum of amoxicillin to include many
bacteria normally resistant to amoxicillin and other β-lactam antibiotics. Thus,
amoxicillin/clavulanate potassium possesses the properties of a broad-spectrum
antibiotic and a β-lactamase inhibitor.
Amoxicillin/clavulanic acid has been shown to be active against most strains
of the following microorganisms, both in vitro and in
clinical infections as described in the INDICATIONS AND USAGE section.
Gram-Positive Aerobes:Staphylococcus aureus (β-lactamase and
non-β-lactamase producing).‡
‡ Staphylococci which are resistant to methicillin/oxacillin must be
considered resistant to amoxicillin/clavulanic acid.
Gram-Negative Aerobes:Enterobacter species (Although most
strains of Enterobacter species are resistant in vitro, clinical efficacy has been demonstrated with
amoxicillin/clavulanate potassium in urinary tract infections caused by these
organisms.)
Escherichia coli (β-lactamase and non-β-lactamase
producing)
Haemophilus influenzae (β-lactamase and
non-β-lactamase producing)
Klebsiella species (All known strains are
β-lactamase producing.)
Moraxella catarrhalis (β-lactamase and
non-β-lactamase producing)
The following in vitro data are available, but their clinical significance
is unknown
.
Amoxicillin/clavulanic acid exhibits in vitro
minimal inhibitory concentrations (MICs) of 2 mcg/mL or less against most (≥90%)
strains of Streptococcus pneumoniae§; MICs of 0.06 mcg/mL or less against most (≥90%)
strains of Neisseria gonorrhoeae; MICs of 4 mcg/mL or
less against most (≥90%) strains of staphylococci and anaerobic bacteria; and
MICs of 8 mcg/mL or less against most (≥90%) strains of other listed organisms.
However, with the exception of organisms shown to respond to amoxicillin alone,
the safety and effectiveness of amoxicillin/clavulanic acid in treating clinical
infections due to these microorganisms have not been established in adequate and
well-controlled clinical trials.
§Because amoxicillin has
greater in vitro activity against S. pneumoniae than does ampicillin or penicillin, the
majority of S. pneumoniae strains with intermediate
susceptibility to ampicillin or penicillin are fully susceptible to
amoxicillin.
Gram-Positive Aerobes:Enterococcus faecalisII
Staphylococcus epidermidis (β-lactamase and
non-β-lactamase producing)
Staphylococcus saprophyticus (β-lactamase and
non-β-lactamase producing)
Streptococcus pneumoniae
II¶ ,
Streptococcus pyogenes II¶
viridans group Streptococcus
II¶
Gram-Negative Aerobes:Eikenella corrodens (β-lactamase and
non-β-lactamase producing)
Neisseria gonorrhoeae II
(β-lactamase and non-β-lactamase producing)
Proteus mirabilis II
(β-lactamase and non-β-lactamase producing)
Anaerobic Bacteria:Bacteroides species, including Bacteroides fragilis (β-lactamase and non-β-lactamase
producing)
Fusobacterium species (β-lactamase and
non-β-lactamase producing)
Peptostreptococcus species¶
II Adequate and well-controlled clinical trials have
established the effectiveness of amoxicillin alone in treating certain clinical
infections due to these organisms.
¶ Those are
non-β-lactamase-producing organisms and, therefore, are susceptible to
amoxicillin alone.
Susceptibility Testing:
Dilution Techniques: Quantitative
methods are used to determine antimicrobial minimal inhibitory concentrations
(MICs). Those MICs provide estimates of the susceptibility of bacteria to
antimicrobial compounds. The MICs should be determined using a standardized
procedure. Standardized procedures are based on a dilution method1 (broth or agar) or equivalent with standardized inoculum
concentrations and standardized concentrations of amoxicillin/clavulanate
potassium powder.
The recommended dilution pattern utilizes a constant amoxicillin/clavulanate
potassium ratio of 2 to 1 in all tubes with varying amounts of amoxicillin. MICs
are expressed in terms of the amoxicillin concentration in the presence of
clavulanic acid at a constant 2 parts amoxicillin to 1 part clavulanic acid. The
MIC values should be interpreted according to the following criteria:
RECOMMENDED RANGES FOR AMOXICILLIN/CLAVULANIC ACID SUSCEPTIBILITY
TESTING
| For Gram-Negative
Enteric Aerobes: |
| MIC (mcg/mL) | Interpretation |
| ≤ 8/4 | Susceptible (S) |
| 16/8 | Intermediate (I) |
| ≥ 32/16 | Resistant (R) |
| For Staphylococcus** and Haemophilus species: |
| MIC (mcg/mL) | Interpretation |
| ≤ 4/2 | Susceptible (S) |
| ≥ 8/4 | Resistant (R) |
**Staphylococci which are susceptible to amoxicillin/clavulanic acid but
resistant to methicillin/oxacillin must be considered as resistant.
For
Streptococcus
pneumoniae from non-meningitis sources:
Isolates should be tested using amoxicillin/clavulanic acid and
the following criteria should be used:
| MIC (mcg/mL) | Interpretation |
| ≤ 2/1 | Susceptible (S) |
| 4/2 | Intermediate (I) |
| ≥ 8/4 | Resistant (R) |
Note: These interpretive criteria are based on the recommended doses for
respiratory tract infections.
A report of “Susceptible” indicates that the pathogen is likely to be
inhibited if the antimicrobial compound in the blood reaches the concentration
usually achievable. A report of “Intermediate” indicates that the result should
be considered equivocal, and, if the microorganism is not fully susceptible to
alternative, clinically feasible drugs, the test should be repeated. This
category implies possible clinical applicability in body sites where the drug is
physiologically concentrated or in situations where high dosage of drug can be
used. This category also provides a buffer zone which prevents small
uncontrolled technical factors from causing major discrepancies in
interpretation. A report of “Resistant” indicates that the pathogen is not
likely to be inhibited if the antimicrobial compound in the blood reaches the
concentrations usually achievable; other therapy should be selected.
Standardized susceptibility test procedures require the use of laboratory
control microorganisms to control the technical aspects of the laboratory
procedures. Standard amoxicillin/clavulanate potassium powder should provide the
following MIC values:
| MicroorganismMIC Range
(mcg/mL) ††
|
| Escherichia coli | ATCC 25922 | 2 to 8 |
| Escherichia coli | ATCC 35218 | 4 to 16 |
| Enterococcus faecalis | ATCC 29212 | 0.25 to 1.0 |
| Haemophilus influenzae | ATCC 49247 | 2 to 16 |
| Staphylococcus aureus | ATCC 29213 | 0.12 to 0.5 |
| Streptococcus
pneumoniae | ATCC 49619 | 0.03 to 0.12 |
††Expressed as concentration of amoxicillin in the
presence of clavulanic acid at a constant 2 parts amoxicillin to 1 part
clavulanic acid.
Diffusion Techniques:
Quantitative methods that require measurement of zone diameters
also provide reproducible estimates of the susceptibility of bacteria to
antimicrobial compounds. One such standardized procedure2
requires the use of standardized inoculum concentrations. This procedure uses
paper disks impregnated with 30 mcg of amoxicillin/clavulanate potassium (20 mcg
amoxicillin plus 10 mcg clavulanate potassium) to test the susceptibility of
microorganisms to amoxicillin/clavulanic acid.
Reports from the laboratory providing results of the standard single-disk
susceptibility test with a 30 mcg amoxicillin/clavulanate potassium (20 mcg
amoxicillin plus 10 mcg clavulanate potassium) disk should be interpreted
according to the following criteria:
RECOMMENDED RANGES FOR AMOXICILLIN/CLAVULANIC ACID SUSCEPTIBILITY TESTING
For Staphylococcus‡
‡ species and H.
influenzae
a
| Zone Diameter
(mm) | Interpretation |
| ≥ 20 | Susceptible (S) |
| ≤ 19 | Resistant (R) |
For Other Organisms Except S.
pneumoniae
b and N.
gonorrhoeae
c
| Zone Diameter
(mm) | Interpretation |
| ≥ 18 | Susceptible (S) |
| 14 to 17 | Intermediate (I) |
| ≤ 13 | Resistant (R) |
‡‡ Staphylococci which are resistant to
methicillin/oxacillin must be considered as resistant to amoxicillin/clavulanic
acid.
a A broth microdilution method
should be used for testing H. influenzae.
Beta-lactamase negative, ampicillin-resistant strains must be considered
resistant to amoxicillin/clavulanic acid.
b Susceptibility of S. pneumoniae should be determined using a 1-mcg oxacillin
disk. Isolates with oxacillin zone sizes of ≥20 mm are susceptible to
amoxicillin/clavulanic acid. An amoxicillin/clavulanic acid MIC should be
determined on isolates of S.
pneumoniae with oxacillin zone sizes of ≤19 mm.
c A broth microdilution method
should be used for testing N. gonorrhoeae and
interpreted according to penicillin breakpoints.
Interpretation should be as stated above for results using dilution
techniques. Interpretation involves correlation of the diameter obtained in the
disk test with the MIC for amoxicillin/clavulanic acid.
As with standardized dilution techniques, diffusion methods require the use
of laboratory control microorganisms that are used to control the technical
aspects of the laboratory procedures. For the diffusion technique, the 30-mcg
amoxicillin/clavulanate potassium (20 mcg amoxicillin plus 10-mcg clavulanate
potassium) disk should provide the following zone diameters in these laboratory
quality control strains.
| Microorganism | Zone Diameter
(mm) |
| Escherichia coli |
|
| ATCC 25922 | 19 to 25 |
| Escherichia coli |
|
| ATCC 35218 | 18 to 22 |
| Staphylococcus aureus |
|
| ATCC 25923 | 28 to 36 |