POTASSIUM CHLORIDE INJECTION

For Use Only With A Calibrated Infusion Device

Highly Concentrated

Flexible Plastic Container

Ready To Use

R_x only

This Potassium Chloride Injection is a sterile, nonpyrogenic, highly concentrated, ready-to-use solution of Potassium Chloride, USP in Water for Injection, USP for electrolyte replenishment in a single dose container for intravenous administration. It contains no antimicrobial agents.

*Normal physiologic osmolarity range is approximately 280 to 310 mOsmol/L. Administration of substantially hypertonic solutions (≥600 mOsmol/L) may cause vein damage.

This flexible plastic container is fabricated from a specially formulated polyvinylchloride. Exposure to temperatures above 25°C (77°F) during transport and storage will lead to minor losses in moisture content. Higher temperatures lead to greater losses. It is unlikely that these minor losses will lead to clinically significant changes within the expiration period. The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container may leach out certain of its chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials.

Potassium is the major cation of body cells (160 mEq/liter of intracellular water) and is concerned with the maintenance of body fluid composition and electrolyte balance. Potassium participates in carbohydrate utilization, protein synthesis, and is critical in the regulation of nerve conduction and muscle contraction, particularly in the heart. Chloride, the major extracellular anion, closely follows the metabolism of sodium, and changes in the acid-base of the body are reflected by changes in the chloride concentration.

Normally about 80 to 90% of the potassium intake is excreted in the urine, the remainder in the stools and to a small extent, in the perspiration. The kidney does not conserve potassium well so that during fasting, or in patients on a potassium-free diet, potassium loss from the body continues resulting in potassium depletion. A deficiency of either potassium or chloride will lead to a deficit of the other.

Potassium Chloride Injection is indicated in the treatment of potassium deficiency states when oral replacement is not feasible.

THIS HIGHLY CONCENTRATED, READY-TO-USE POTASSIUM CHLORIDE INJECTION IS INTENDED FOR THE MAINTENANCE OF SERUM K ⁺ LEVELS AND FOR POTASSIUM SUPPLEMENTATION IN FLUID RESTRICTED PATIENTS WHO CANNOT ACCOMMODATE ADDITIONAL VOLUMES OF FLUID ASSOCIATED WITH POTASSIUM SOLUTIONS OF LOWER CONCENTRATION.

When using these products, these patients should be on continuous cardiac monitoring and frequent testing for serum potassium concentration and acid-base balance.

Potassium Chloride Injection is contraindicated in diseases where high potassium levels may be encountered, and in patients with hyperkalemia, renal failure and in conditions in which potassium retention is present.

THIS HIGHLY CONCENTRATED, READY-TO-USE POTASSIUM CHLORIDE INJECTION IS INTENDED FOR THE MAINTENANCE OF SERUM K ⁺ LEVELS AND FOR POTASSIUM SUPPLEMENTATION IN FLUID RESTRICTED PATIENTS WHO CANNOT ACCOMMODATE ADDITIONAL VOLUMES OF FLUID ASSOCIATED WITH POTASSIUM SOLUTIONS OF LOWER CONCENTRATION.

TO AVOID POTASSIUM INTOXICATION, DO NOT INFUSE THESE SOLUTIONS RAPIDLY.

PATIENTS REQUIRING HIGHLY CONCENTRATED SOLUTIONS SHOULD BE KEPT ON CONTINUOUS CARDIAC MONITORING AND UNDERGO FREQUENT TESTING FOR SERUM POTASSIUM AND ACID-BASE BALANCE, ESPECIALLY IF THEY RECEIVE DIGITALIS.

In patients with renal insufficiency, administration of potassium chloride may cause potassium intoxication and life-threatening hyperkalemia.

Administer intravenously only with a calibrated infusion device at a slow, controlled rate. (See DOSAGE AND ADMINISTRATION.) Because pain associated with peripheral infusion of Potassium Chloride solution has been reported, whenever possible administration via a central route is recommended for thorough dilution by the blood stream and avoidance of extravasation. Highest concentrations (300 and 400 mEq/L) should be exclusively administered via central route.

The administration of intravenous solutions can cause fluid and/or solute overload resulting in dilution of serum electrolyte concentrations, overhydration, congested states or pulmonary edema. The risk of dilutional states is inversely proportional to the electrolyte concentration. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentration.

Potassium intoxication with mild or severe hyperkalemia has been reported. The signs and symptoms of intoxication include paresthesia of the extremities, areflexia, muscular or respiratory paralysis, mental confusion, weakness, hypotension, cardiac arrhythmia, heart block, electrographic abnormalities and cardiac arrest. EKG abnormalities serve as a clinical reflection of the seriousness of changes in serum potassium concentrations: peaked T waves and prolonged P-R intervals usually occur with modest elevations above the upper limit of normal potassium concentrations; P waves disappear, the QRS complex widens, and eventual asystole usually occurs with higher elevations.

Reactions which may occur because of the solution or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia.

Infusion of highly concentrated potassium chloride solutions may cause local pain and vein irritation. (See WARNINGS).

Reactions reported with the use of potassium-containing solutions include nausea, vomiting, and abdominal pain and diarrhea.

If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures and save the remainder of the fluid for examination if deemed necessary.

In the event of hyperkalemia, discontinue the infusion immediately and institute corrective therapy to reduce serum potassium levels as necessary. The use of potassium containing foods or medications must also be eliminated.

Treatment of mild to severe hyperkalemia with signs and symptoms of potassium intoxication includes the following:

1. Dextrose Injection, USP, 10% or 25%, containing 10 units of crystalline insulin per 20 grams of dextrose administered intravenously, 300 to 500 mL per hour.

2. Absorption and exchange of potassium using sodium or ammonium cycle cation exchange resin, orally and as retention enema.

3. Hemodialysis and peritoneal dialysis.

In cases of digitalization, too rapid a lowering of plasma potassium concentration can cause digitalis toxicity.

The dose and rate of administration are dependent upon the specific condition of each patient.

Administer intravenously only with a calibrated infusion device at a slow, controlled rate. Because pain associated with peripheral infusion of Potassium Chloride solution has been reported, whenever possible, administration via central route is recommended for thorough dilution by the blood stream and avoidance of extravasation. Highest concentrations (300 and 400 mEq/L) should be exclusively administered via central route.

Recommended administration rates should not usually exceed 10 mEq/hour or 200 mEq for a 24-hour period if the serum potassium level is greater than 2.5 mEq/liter.

In urgent cases where the serum potassium level is less than 2 mEq/liter or where severe hypokalemia is a threat (serum potassium level less than 2 mEq/liter and electrocardiographic changes and/or muscle paralysis), rates up to 40 mEq/hour or 400 mEq over a 24-hour period can be administered very carefully when guided by continuous monitoring of the EKG and frequent serum K⁺ determinations to avoid hyperkalemia and cardiac arrest.

Parenteral drug products should be inspected visually for particulate matter and discoloration, whenever solution and container permit. Use of a final filter is recommended during administration of all parenteral solutions where possible.

Do not add supplementary medication.

Preparation for Administration

(Use aseptic technique)

1. Close flow control clamp of administration set.

2. Remove cover from outlet port at bottom of container.

3. Insert piercing pin of administration set into port with a twisting motion until the set is firmly seated. NOTE: See full directions on administration set carton.

4. Suspend container from hanger.

5. Squeeze and release drip chamber to establish proper fluid level in chamber.

6. Open flow control clamp and clear air from set. Close clamp.

7. Attach set to venipuncture device. If device is not indwelling, prime and make venipuncture.

8. Regulate rate of administration with flow control clamp.

WARNING: Do not use flexible container in series connections. Do not add supplementary medication. Such use could result in air embolism due to residual air being drawn from the primary container before administration of the fluid from the secondary container is completed.

Potassium Chloride Injection in flexible plastic containers is available as follows:

Store at 20 to 25°C (68 to 77°F). [See USP Controlled Room Temperature.]

Hospira, Inc., Lake Forest, IL 60045 USA

IM-1159

iv bag 0409-7074-26

WR-0354

overwrap 0409-7074-26

IM-1160

iv bag 0409-7076-26

WR-0156

overwrap 0409-7076-26

IM-1171

iv bag 0409-7077-14

WR-0355

overwrap 0409-7077-14

IM-1155

iv bag 0409-7075-14

WR-0353

overwrap 0409-7075-14