Sterile Water for Injection, USP

This preparation is designed solely for parenteral use only after addition to drugs that require dilution or must be dissolved in an aqueous vehicle prior to injection.

Sterile Water for Injection, USP is a sterile, nonpyrogenic preparation of water for injection which contains no bacteriostat, antimicrobial agent or added buffer and is supplied only in single dose containers to dilute or dissolve drugs for injection.  For IV injection, add sufficient amount to a solute to make an approximately isotonic solution. pH 5.0 to 7.0.

Water for Injection, USP is chemically designated H ₂O.

Water is an essential constituent of all body tissues and accounts for approximately 70% of total body weight.  Average normal adult daily requirement ranges from two to three liters (1 to 1.5 liters each for insensible water loss by perspiration and urine production).

Water balance is maintained by various regulatory mechanisms.  Water distribution depends primarily on the concentration of electrolytes in the body compartments and sodium (Na ⁺) plays a major role in maintaining physiologic equilibrium.

The small volume of fluid provided by Sterile Water for Injection, USP when used only as a pharmaceutic aid for diluting or dissolving drugs for parenteral injection, is unlikely to exert a significant effect on fluid balance except possibly in neonates or very small infants.

This parenteral preparation is indicated only for diluting or dissolving drugs for intravenous, intramuscular or subcutaneous injection, according to instructions of the manufacturer of the drug to be administered.

Sterile Water for Injection must be made approximately isotonic prior to use.

Intravenous administration of Sterile Water for Injection without a solute may result in hemolysis.

Do not use for intravenous injection unless the osmolar concentration of additives results in an approximate isotonic admixture.

Consult the manufacturer’s instructions for choice of vehicle, appropriate dilution or volume for dissolving the drugs to be injected, including the route and rate of injection.

Inspect reconstituted (diluted or dissolved) drugs for clarity (if soluble) and freedom from unexpected precipitation or discoloration prior to administration.

Reactions which may occur because of this solution, added drugs or the technique of reconstitution or administration include febrile response, local tenderness, abscess, tissue necrosis or infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection and extravasation.  If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate countermeasures, and if possible, retrieve and save the remainder of the unused vehicle for examination.

Use only as a diluent or solvent.  This parenteral preparation is unlikely to pose a threat of fluid overload except possibly in neonates or very small infants.  In the event these should occur, re-evaluate the patient and institute appropriate corrective measures (see WARNINGS, PRECAUTIONS  and ADVERSE REACTIONS).

The volume of the preparation to be used for diluting or dissolving any drug for injection is dependent on the vehicle concentration, dose and route of administration as recommended by the manufacturer.

This parenteral should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

Packaged in a plastic vial.  Vials are packaged 25 vials per tray.

Store at 20° to 25°C (68° to 77°F) [see USP Controlled Room Temperature].

Single dose use.  No preservative added.

Unused portion of vial should be discarded.

Use only if solution is clear and seal intact.

Fresenius Kabi Logo

Lake Zurich, IL 60047

www.fresenius-kabi.com/us

45768H
Revised: April 2022

PACKAGE LABEL - PRINCIPAL DISPLAY - STERILE WATER - 10  mL Single Dose Vial Label

NDC 63323-185-07

918510

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

10 mL  Single Dose Vial

PACKAGE LABEL - PRINCIPAL DISPLAY - STERILE WATER - 10  mL Single Dose Vial Label

PACKAGE LABEL – PRINCIPAL DISPLAY – STERILE WATER – 10 mL Single Dose Vial Tray Label

NDC 63323-185-10

918510

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

10 mL Single Dose Vial

25 Vials

PACKAGE LABEL – PRINCIPAL DISPLAY – STERILE WATER – 20 mL Single Dose Vial Label

NDC 63323-185-08

918520

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

20 mL Single Dose Vial

PACKAGE LABEL – PRINCIPAL DISPLAY – STERILE WATER – 20 mL Single Dose Vial Tray Label

NDC 63323-185-20

918520

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

20 mL Single Dose Vial

25 Vials

PACKAGE LABEL – PRINCIPAL DISPLAY – STERILE WATER – 50 mL Single Dose Vial Label

NDC 63323-185-09

918550

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

50 mL Single Dose Vial

PACKAGE LABEL – PRINCIPAL DISPLAY – STERILE WATER – 50 mL Single Dose Vial Tray Label

NDC 63323-185-50

918550

STERILE WATER FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

50 mL Single Dose Vial

25 Vials

PACKAGE LABEL - PRINCIPAL DISPLAY - STERILE WATER - 5 mL Single Dose Vial Label

NDC 63323-185-04

18505

STERILE WATER

FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

5 mL Single Dose Vial

PACKAGE LABEL - PRINCIPAL DISPLAY - STERILE WATER - 5 mL Single Dose Tray Label

NDC 63323-185-05

18505

STERILE WATER

FOR INJECTION, USP

FOR DRUG DILUENT USE ONLY

Rx only

5 mL Single Dose Vial

25 Vials