DIRECTIONS
IMPORTANT THIS IS A TWO-PART CONCENTRATE - MUST BE MIXED PRIOR TO USE. MIX RATIO is (48 Water: 1 Activator. 1 Base), In a clean container, add (48) partS water, then add (1) part CD X-10 Pre-Post Activator, next add (1) part CD X-10 Pre-Post Base. CREATES CHLORINE DIOXIDE.
General Use
- Use a teat dip cup to apply. Clean dip cup just prior to use.
- If cow's teats are sore or chapped, consult a veterinarian before starting or continuing to use teat dip.
- If transferred from this container to any other, make sure that the other container is thorougly pre-cleaned and bears the proper container labeling for this product.
- If product in dip cup becomes visibly dirty, discard contents and replenish with undiluted product. Do not reuse or return any unused product to the original container.
- Teat Sprays can also be foamed or sprayed using recommended equipment.
Pre-Dipping Use
- Perform forestripping and inspect teats for clinical mastitis.
- Pre-Wash teats thoroughly just prior milking with appropriate udder wash solution or pre-milking teat dip. Teats should then be dried with single-service towels.
- Just before each cow is milked, dip, foam, or spray, each teat full-length into the teat dip or foam cup containing product.
- Allow product to stand for 30 seconds.
- Wipe teats dry after dipping, using single-service towels to avoid contamination of milk.
Post-Dipping Use
- Immediately after each milking, use product.
- Dip each teat full-length into the teat dip cup containing product. Allow to air dry. Do not wipe.
- If outside temperature is below freezing, allow to air dry on the teat before cow leaves the parlor.
Extended Use
- When a cow is being dried off, the teats should be dipped in product, once a day for 3-4 days after the last milking.
- Dipping should be resumed at least twice daily one week before calving.