2.1 Dosing Considerations
Whenever possible, administer Phytonadione Injectable Emulsion, USP by the subcutaneous route [see Boxed Warning]. When intravenous administration is unavoidable, inject the drug very slowly, not exceeding 1 mg per minute [see Warnings and Precautions (5.1)].
Monitor international normalized ratio (INR) regularly and as clinical conditions indicate. Use the lowest dose of Phytonadione Injectable Emulsion, USP.
The coagulant effects of Phytonadione Injectable Emulsion, USP are not immediate; improvement of INR may take 1-8 hours. Interim use of whole blood or component therapy may also be necessary if bleeding is severe.
Whenever possible, administer benzyl alcohol-free formulations in pediatric patients [see Warnings and Precautions (5.2), Use in Specific Populations (8.4)].
When Phytonadione Injectable Emulsion, USP is used to correct excessive anticoagulant-induced hypoprothrombinemia, anticoagulant therapy still being indicated, the patient is again faced with the clotting hazards existing prior to starting the anticoagulant therapy. Phytonadione Injectable Emulsion, USP is not a clotting agent, but overzealous therapy with Phytonadione Injectable Emulsion, USP may restore conditions which originally permitted thromboembolic phenomena. Dosage should be kept as low as possible, and INR should be checked regularly as clinical conditions indicate.
2.2 Recommended Dosage for Coagulation Disorders from Vitamin K Deficiency or Interference
The recommended dosage of Phytonadione Injectable Emulsion, USP is based on whether the hypoprothrombinemia is anticoagulant-induced (e.g., due to coumarin or indanedione derivatives) or non-anticoagulant-induced (e.g., due to antibiotics; salicylates or other drugs; factors limiting absorption or synthesis) as follows:
- Anticoagulant-induced Hypoprothrombinemia: Phytonadione Injectable Emulsion, USP 2.5 mg to 10 mg or more subcutaneously, intramuscularly, or intravenously. Up to 25 mg to 50 mg may be administered as a single dose.
Repeated large doses of Phytonadione Injectable Emulsion, USP are not warranted in liver disease if the initial response is unsatisfactory. Failure to respond to Phytonadione Injectable Emulsion, USP may indicate that the condition being treated is inherently unresponsive to Phytonadione Injectable Emulsion, USP.
- Hyppoprothrombinemia Due to Other Causes (Non-Anticoagulation-Induced Hypoprothrombinemia: Phytonadione Injectable Emulsion, USP 2.5 mg to 25 mg or more intravenously, intramuscularly, or subcutaneously. Up to 50 mg may be administered as a single dose.
Evaluate INR after 6-8 hours, and repeat dose if INR remains prolonged. Modify subsequent dosage (amount and frequency) based on the INR or clinical condition.
2.3 Recommended Dosage for Prophylaxis and Treatment of Vitamin K Deficiency Bleeding in Neonates
Prophylaxis of Vitamin K-Deficiency Bleeding in Neonates
The recommended dosage of Phytonadione Injectable Emulsion, USP is 0.5 mg to 1 mg within one hour of birth for a single dose.
Treatment of Vitamin K Deficiency Bleeding in Neonates
The recommended dosage of Phytonadione Injectable Emulsion, USP is 1 mg given either subcutaneously or intramuscularly.
Consider higher doses if the mother has been receiving oral anticoagulants.
A failure to respond (shortening of the INR in 2 to 4 hours) may indicate another diagnosis or coagulation disorder.
2.4 Directions for Dilution
Dilute Phytonadione Injectable Emulsion, USP with 0.9% Sodium Chloride Injection, 5% Dextrose Injection, or 5% Dextrose and Sodium Chloride Injection. Avoid use of other dilutents that may contain benzyl alcohol, which can cause serious toxicity in newborns or low birth weight infants [see Warnings and Precautions (5.2) and Use in Specific Populations (8.4)].
When diluted, start administration of Phytonadione Injectable Emulsion, USP immediately after dilution.
Discard unused portions of diluted solution as well as unused contents of the vial.
Protect Phytonadione Injectable Emulsion, USP from light at all times.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to adminstration, whenever solution and container permit.