Alfa Veterinary 10% Dextrose

10% dextrose solution is sterile, non-pyrogenic for fluid and calorie replacement, and is supplied in single-dose containers for intravenous administration. Discard the unused portion. Does not contain antimicrobial agents.

Chemically, dextrose (glucose) is a monosaccaride containing an aldehyde group (an aldose). In water it exists primarily as a six membered hemi-acetal ring in equilibrium with a minor amount of the free aldehyde form and a five membered hemicetal form. Dextrose used is either an anhydrous or monohydrate form.

The Plastic container, a semi-rigid bottle, is made of a low-denisty polyethylene which is a flexible and resistant material. No venting is necessary during infusion.

 No venting is necessary during infusion.

10% Dextrose solution has value as a source of water and calories. It is capable of inducing diuresis depending on the clinical condition of the partient.

Glucose is a nutrient of the first order, provides 4.1Kcal per gram and like all carbohydrates has the property of decreasing catabolism.

10% dextrose dolution has value as a source of water and calories. It is used to decrease the excessive pressure of spinal brain fluid, also a scloerisng to treat varicose veins and decrease intracranial pressure.

Veterinary 10% Dextrose Injection should not be administered simultaneously with blood through the same administration set because of the possibility of pseudo agglutination or hemolysis.

The intravenous administration of 10% Dextrose Injection can cause fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, over hydration, congested states, or pulmonary edema.

The risk of dilutive states is inversely proportional to the electrolyte concentrations of the injections.

The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentrations of the injections.

Excessive administration of dextrose injections may result in significant hypokalemia.

The container label for these injections bears the statement: Do not administer simultaneously with blood.

Keep out of the reach of children.

Reactions which may occur because of the injection or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia.

If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures and save the remainder of the fluid for examination if deemed necessary.

Veterinary 10% Dextrose Injection, USP should be used with caution in patients with known overt or subclinical diabetes mellitus.

Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations and acid base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation.

This is a hypotonic solution and as such should not be used for resuscitation.

Do not administer unless solution is clear and both seal and container are intact.

As directed by a veterinarian. Dosage is dependent upon the age, weight and clinical condition of the patient as well as laboratory determinations.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.

All injections in plastic containers are intended for intravenous administration using sterile equipment.

Additives may be incompatible. Complete information is not available. Those additives known to be incompatible should not be used. Consult with veterinarian, if available. If, in the informed judgment of the veterinarian, it is deemed advisable to introduce additives, use aseptic technique. Mix thoroughly when additives have been introduced.

Do not store solutions containing additives. Discard unused portion.

In an event of over hydration or solute overload, re-evaluate the patient and institute appropriate corrective measures. See Warnings, Precautions, and Adverse Reactions.

Store below 30ºC (86ºF).

This is a single dose container and does not contain preservatives. Use the solution immediately after the bottle is opened, discard the remaining one. Squeeze and inspect the bottle, discard if leaks are found or if the solution contains visible and solid particles.

Do not administer simultaneously with blood.

Do not use it unless solution is clear, and seal is intact.

Preparation and administration

1. Check for minute leaks by squeezing the container firmly. If leaks are found, discard solution as sterility may be impaired.

2. Suspend container from eyelet support.

3. Remove Plastic protector from ports area at the bottom of container.

4. Hold the bottle in vertical position and inset pyrogen free IV administration set in the outlet port. Use aseptic Technique

To add medication

WARNING: Additives may be incompatible.

To add medication before solution administration
1. Prepare medication site.
2. Using syringe with 19 to 22 gauge needle, puncture inlet port and inject.
3. Mix solution and medication thoroughly. For high density medication such as potassium chloride, squeeze ports while ports are upright and mix thoroughly.
To add medication during solution administration
1. Close clamp on the set.
2. Prepare medication site.
3. Using syringe with 18 to 21 gauge needle, puncture inlet port and inject.
4. Remove container from IV pole and/or turn to an upright position.
5. Mix solution and medication thoroughly.
6. Return container to in use position and continue administration.

CAUTION: Federal law (USA) restricts this drug to use by or on the order of a licensed veterinarian.

For Animal Use Only.

INSERT_10 Dextrose_page 1INSERT_10 Dextrose_page 2INSERT_10 Dextrose_page 3INSERT_10 Dextrose_page 4INSERT_10 Dextrose_page 5

Veterinary 10% Dextrose Injection, USP

NDC: 72483-201-10 1000 mL 10% Dextrose

NDC: 72483-201-05 500 mL 10% Dextrose

NDC: 72483-201-25 250 mL 10% Dextrose

NDC: 72483-201-01 100 mL 10% Dextrose

BOTTLE_10 Dextrose_100 mlBOTTLE_10 Dextrose_250 mlBOTTLE_10 Dextrose_500 mlBOTTLE_10 Dextrose_1000 ml

Veterinary 10% Dextrose Injection, USP

NDC: 72483-201-02 5000 mL 10% Dextrose

NDC: 72483-201-03 3000 mL 10% Dextrose

NDC: 72483-201-04 1000 mL 10% Dextrose

NDC: 72483-201-06 500 mL 10% Dextrose

NDC: 72483-201-07 250 mL 10% Dextrose

NDC: 72483-201-08 100 mL 10% Dextrose

BAG_10 Dextrose_100 mlBAG_10 Dextrose_250 mlBAG_10 Dextrose_500 mlBAG_10 Dextrose_1000 mlBAG_10 Dextrose_3000 mlBAG_10 Dextrose_5000 ml